Vetra lv- 401 20gm

Vetra LV-401 is a low viscosity, ethyl cyanoacrylate adhesive, which is suitable for bonding a very wide range of materials where very fast cure speed is required. When a thin layer of Vetra LV-401 is applied between two surfaces, it comes into contact with atmospheric moisture, a rapid polymerization occurs producing the ultimate bond.

Vetra LV-401 is specially formulated for high strength, general purpose bonding of most of the non-porous substrates like plastics, rubbers, metals and porous substrates like wood, leather etc. It is recommended for use on assemblies with very close fitting parts and smooth, even surfaces. It can also be used as a post-assembly adhesive to wick into parts.

• Make sure the surfaces to be bonded are clean and dry (preferable to solvent-wipe plastics, glass, and rubber, and to acid-treat metals).
• Dispense a drop or drops to one surface only. Apply only enough to leave a thin film after compression.
• Press parts together and hold firmly for a few seconds. Good contact is essential. An adequate bond develops in less than one minute.
• Wipe off excess adhesive from the top of the container and recap Vetra LV-401 if left uncapped, may deteriorate by contamination from moisture in the air.
• Because Vetra LV-401 condenses by polymerization, sometimes whitening will occur on the surface of the container.

It will not bond PTFE, nylon, polypropylene etc.

12 months from date of manufacturing. It comes without a warranty as storage condition will affect the shelf life.